Table of Contents
Advertisement
GSM-204-423
Procedure for
installing
template
The template must be secured to the concrete base before drilling the mounting
holes for the M12 anchor bolts.
1.
2.
3.
4.
5.
6.
Recommended
bolt length for
concrete base
The length of the M12 steel anchor bolts must be determined by a structural
engineer, but must be of sufficient strength to withstand 105 knot (120 mph)
winds on the cabinet front or rear for a maximum gross weight of 360 kg.
31st Oct 01
Installing the template and mounting bolt anchors
Move the cabinet template to the selected mounting position.
Mark the positions of the two template mounting screw holes in the
template.
WARNING
Wear safety glasses and a dust mask when drilling holes.
CAUTION
Drilling concrete flooring produces cement dust, which is
harmful to equipment and wiring. Protect the cabinets and
any nearby equipment from dust. Use a tarpaulin, cloth, or
plastic sheeting to cover exposed equipment. Clean up
any accumulated debris from the anchor installation
carefully before exposing the equipment. Use drilling
equipment suitable for cutting steel reinforced concrete.
Drill out the two holes to a depth and clearance for No. 10 screws.
Fit plastic expanding plugs into the mounting holes.
Position the template over the mounting holes and secure using No. 10
screws.
When satisfied that the template is correctly installed, carry out procedure
for installing the cabinet anchor bolts.
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
Inst. 3–13
Advertisement
Table of Contents
