Motorola Horizonmacro outdoor Installation/Configuration Manual page 64

Unpacking and preparing the cabinet
Cabinet access
procedures
Cabinet access procedures include:
S
S
Door opening and closing
The door lock has a spring loaded handle. The door is operated as follows:
1.
2.
3.
4.
5.
6.
7.
Lid opening and closing
The lid is opened as follows:
1.
2.
3.
The lid is closed as follows:
1.
2.
3.
4.
Inst. 3–8
Door and lid opening and closing.
TMS front cover removal and refitting.
Insert key into lock and turn clockwise until spring loaded handle releases.
Turn handle a quarter turn anti-clockwise to open the lock.
Open power supply enclosure door to 90_ locking position.
Open radio enclosure door to 90_ locking position.
NOTE If the equipment is active, a door open alarm will be
generated.
To open doors to 120_, lift up middle of appropriate wind stop.
To close, lift up middle of wind stop, close doors firmly, radio enclosure
door first.
Turn handle a quarter turn clockwise, push handle flush and remove key
to lock the door.
NOTE The lid can only be opened and closed when both doors
are open.
Ensure both cabinet doors are open to the 90_ position.
Undo the two draw latches by turning anti-clockwise, and ensure the catch
hook is clear of lip on the lid.
Lift the lid until the mechanical stay audibly locks.
Press the lock stud on the mechanical stay to release.
Lower the lid.
Hook the draw latches over the lip and turn clockwise to lock.
Ensure operating tab is stowed flat.
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
GSM-204-423
31st Oct 01