Discovery Report Example; Discovery Report Example Content - 3Com 3C15500 - Network Director User Manual

Discovery Report
Example Content
This section discusses the contents of a typical 3Com Network Director
Discovery Report.
The following devices stopped responding while 3Com Network
Director attempted to read topology information from them
This is as it says. The device must have responded at some point for the
application to have discovered it. Currently the user has no means of
increasing the timeout values, although there is a multiplying factor
stored in SITimeoutRetry.properties.
The following devices are running with an unsupported version of
the management agent software
Each device type has a text file associated with it which stores the
supported agent versions. If the version read from the device does not
match any of the values in that file this warning will be logged. The
application will still continue attempting to read information from the
device.
The following devices are running with an unknown version of
the management agent software
The application could not determine the agent software version. It is
therefore likely that it is an unsupported version.
The VLAN configuration of the following devices could not be
determined
This is likely to be if the agent is not a supported version.
The following devices have been configured into multiple
segments
Port Switch Hub 40 and 50 allowed the separation of groups of ports into
segments. 3Com Network Director does not support this scenario.
The segment configuration of the following devices could not be
determined
This may occur if the agent version is not supported.

Discovery Report Example Content

863