Specify Device Being Replaced Step - 3Com 3C15500 - Network Director User Manual

788 C 19: B U D C
HAPTER ACKING P EVICE ONFIGURATIONS
Figure 429 Device Restore Wizard - No Backups Found
If your target device is not a replacement for another device and there are
no backup files associated with your target device, the Device Restore
Wizard cannot continue. The Restore operation can only be used to apply
a saved backup to either the device from which it originated or to a
replacement for the device.
If you want to apply a saved configuration to a device which is neither the
source of the backup nor a replacement for the source of the backup,
then you should use the Device Setup Wizard. See "Device Setup
Wizard" on page 792 for more details.

Specify Device Being Replaced Step

When you indicate in the No Backups Found step that the target device is
a replacement for another device, the Specify Device Being Replaced step
is shown. This step is only shown if there is at least one backup from
another device with the same physical configuration as your target
device.
You must select the device that has been replaced by your target device
from the table, as shown in Figure 430.