Adding An Ip Routing Interface - 3Com 3C15500 - Network Director User Manual

Components 547
Figure 294 Manually Configuring a VLAN on Unsupported Devices
The Switches: list contains all the switches on which the new VLAN will
have to be manually created. The table below lists those ports that will
need to be manually added to the new VLAN on the switch currently
selected in the list and indicates whether the ports should be tagged or
untagged based on the rules explained in "Modifying the list of selected
switches and ports" on page 553.
You can either manually configure these unsupported devices at this
point in the wizard, or wait until 3Com Network Director has
automatically created the VLAN on all the supported devices before
manually configuring the unsupported devices. If you choose to manually
configure the unsupported devices at this point in the wizard, you can
use the Launch button to launch the Telnet or Web management
interface for the selected device.

Adding an IP routing interface

The next wizard stage allows you to specify a new IP routing interface(s)
to be used with the new VLAN. See "Communication between VLANs"
on page 504 for more information.