Properties Dialog Box For A Supported Device - 3Com 3C15500 - Network Director User Manual

Properties Dialog Box
for a Supported
Device
If the map item is a device supported by 3Com Network Director, the
Properties dialog box shows a tree on the left-hand side of the dialog
box, with the tabbed pane on the right-hand side of the dialog box.
The tree shows the individual ports on the device. Select the port in the
tree to view the properties for that port. The tabs available for a port are
shown in Table 38.
Table 38 Tabs for a Port
Tab Title Contents
General General settings for the port, such as speed, duplex mode, etc.
Custom information, such as comments
Power over Information regarding the power over Ethernet settings and usage for
Ethernet the selected port at the end of a link.
VLANs The VLANs that port belongs to, whether the port is tagged, etc.
If a port is not operating at its full capacity, this is indicated. For instance it
may be operating at 10Mbps when it is capable of 100Mbps, or
operating in half duplex when it is capable of full duplex.
The tree also shows the individual interfaces on the device that could not
be mapped to ports. Select the ifIndex of the interface in the tree to view
the properties for that interface. The tabs available for an interface are
shown in Table 39.
Table 39 Tabs for an interface
Tab Title Contents
General General settings for the interface, such as media type, speed, IP
address, etc.
Custom information, such as comments
VLANs The VLANs that interface belongs to, whether the interface is tagged,
etc.
The tree also shows the aggregated links set up on the device. The tabs
available for an aggregated link are shown in
Components
Table 40.
237