Add Trap Destination Dialog Box; Configuring Spanning Tree - 3Com 3C15500 - Network Director User Manual

Components 603
Any of the trap destination entries can be removed from the list, by
selecting the entries in the list and clicking the Remove button.
3Com Network Director can be configured to create a temporary entry in
the trap destination table of all devices that it manages. This temporary
entry will be removed by the bulk configuration operation if it is not
added to the trap table in this feature panel. Consequently, this could
prevent 3Com Network Director from successfully monitoring the
network devices.
Not all devices support as many trap destinations as the configuration
template allows to be entered. In addition, the bulk configuration
operation will not remove existing trap destination entries that have been
created by 3Com management if the associated checkbox has been
checked in the feature configuration panel. As a result it may not be
possible for the bulk configuration operation to add all of the trap
destinations specified to every device. The bulk configuration operation
adds trap destinations to the devices in the order they are shown in the
list; in the event that not all trap destinations can be added to a device a
warning will be given in the summary report for the operation.

Add Trap Destination Dialog Box

Figure 328 Add Trap Destination Dialog Box
The Add Trap Destination dialog box allows the user to add a new entry
to the trap destination table. The IP address and community string must
be specified; the owner description is optional.

Configuring Spanning Tree

The Spanning Tree feature allows the user to configure the bridge
Spanning Tree Protocol settings on the devices.