792
C
19: B
HAPTER
ACKING
Device Restore Event
Restore Summary
Report
Setup Components
Device Setup Wizard
U
D
C
P
EVICE
ONFIGURATIONS
You can cancel the Device Restore operation at any time. If you do cancel
the operation then the configuration of the target device may be left in
an inconsistent state.
The alarm source is the IP address of the target device and both the alarm
severity and the alarm message indicate whether the attempt to restore
the saved software configuration to the device was successful. The detail
of the alarm message for a successful operation includes the label of the
backup that was applied to the target device. The detail of the alarm
message for an unsuccessful operation describes what went wrong.
You can view the Restore Summary report at any time after the operation
has completed from the History tab of the Reports dialog box, launched
from Tools > Reports.
When the Device Restore operation completes, the Restore Summary
report is automatically generated. You can choose to view the report
from the Device Restore Summary dialog box that is shown at the end of
the operation.
The Restore Summary report details the following:
The label and description of the saved backup that the Device Restore
operation attempted to apply to the target device.
The details of the target device for the operation
The result of the Device Restore operation including a further
explanation where appropriate.
You can view the Restore Summary report at any time after the operation
have completed from the History tab of the Reports dialog box, launched
from Tools > Reports.
The following section describes how to use the Device Setup feature of
3Com Network Director.
You can apply a software configuration to one or more target devices.
The software configuration you choose to apply to the target device can
be either the software configuration of a device on your network or a
software configuration saved in a backup file. The target device (or