Device Setup Event; Setup Summary Report - 3Com 3C15500 - Network Director User Manual

798 C 19: B
HAPTER ACKING

Device Setup Event

Setup Summary
Report
U D C
P EVICE ONFIGURATIONS
The alarm source is the IP address of the device and both the alarm
severity and the alarm message indicate whether the attempt to apply the
source software configuration to the device was successful. The detail of
the alarm message for a successfully configured device identifies the
source device or backup that provided the software configuration. For
devices that could not be configured, the detail of the alarm message
describes what went wrong.
If you choose to cancel a Device Setup operation before it is complete, no
alarms will be generated for target devices that are still pending or in
progress at that time.
When the Device Setup operation completes, the Setup Summary report
is automatically generated. You can choose whether to view the report or
not from the Device Setup Summary dialog box that is shown at the end
of the operation.
The Setup Summary report covers the following:
The details of the source device or backup that provided the software
configuration.
The devices that were successfully configured by the Device Setup
operation.
The devices that could not be configured by the Device Setup
operation. 3Com Network Director reports a reason for each failure.
You can view the Setup Summary report at any time after the operation
has completed from the History tab of the Reports dialog box, launched
from Tools > Reports.