Nbx Step - 3Com 3C15500 - Network Director User Manual

Network-wide Configuration — applies the selected configuration
to all of the supported 3Com devices in the current map. 3Com
recommends that you use this configuration type whenever you
intend to make changes to your selection or when you are first
configuring traffic prioritization on your network. If a new
configuration is not applied across all of the devices then end-to-end
traffic prioritization may not be possible.
Device Type Configuration — applies the selected configuration to
all of the devices of a specific type in the current map. 3Com
recommends that you only use this configuration type when you have
added a large number of devices of a particular type to your network
and you wish to configure them to participate in a previously
configured end-to-end traffic prioritization.
Custom Configuration — allows you to choose which of the
supported 3Com devices in your network that the wizard should apply
the selected configuration to. 3Com recommends that you only use
this configuration type when you have added new devices to your
network and you wish to configure them to participate in a previously
configured end-to-end traffic prioritization.

NBX Step

If your map contains an NBX network call processor then 3Com Network
Director will detect this and automatically select NBX phone traffic for
prioritization. 3Com Network Director will indicate that it has done this
by displaying the NBX step:
Components 633