Accessing The Command Line Interface Over The Network Logging In To The Command Line Interface - 3Com SUPERSTACK 3 WEBCACHE 3000 User Manual

Accessing the
Command Line
Interface Over the
Network
Logging In To the
Command Line
Interface
To configure the settings of the terminal, terminal emulator, or modem,
see the documentation that accompanies it. You must configure the
terminal and set the line speed (baud) to match that of the Webcache
console port. Unless you have changed it, the default line speed is 9600
baud. You can change the baud rate of the console port via the Web
interface.
2 Access the Command Line Interface using a valid user name and
password. Default user names and passwords are described in
in as a Default User"
3 Configure the basic settings of the Webcache by completing the Getting
Started wizard. For further information, see
Command Line Interface"
To manage the Webcache using the Command Line Interface over a
network using Telnet, open a Telnet session using a terminal emulator by
specifying the IP address of the Webcache. If you are unsure how to do
this, check the documentation supplied with the Telnet facility.
To log in to the Command Line Interface, take the following steps:
1 Set up your network for Command Line Interface management; for
further information, see
page 82. The login sequence for the Command Line Interface begins as
soon as the Webcache detects a connection to its console port, or as
soon as a Telnet session is started.
If the login sequence does not begin immediately, press Return a few
times until it does begin. If the sequence still does not begin, see
Command Line Interface Problems"
2 At the Login and Password prompts, enter your user name and password.
For further information, see
To prevent unauthorized configuration of the Webcache, 3Com
recommends that you change the default password as soon as possible.
To do this using the Command Line Interface, you need to log in as the
default user and then follow the steps described in
Password" on page
Logging In To the Command Line Interface
on page 88.
on page 74.
"Accessing the Command Line Interface"
on page
"Logging in as a Default User"
266.
"Logging
"Setting Up Using the
280.
on page
"Changing the Admin
83
on
"Solving
88.