Service; Factory Setting (Default Values); Firmware Update/Downgrade; Table 56: Factory Settings - Default Values - WAGO 750 Series Manual

100 Service

12 Service
12.1

Factory Setting (Default Values)

The following values in the registers and parameters are factory settings:
Table 56: Factory Settings – Default Values
Process image
Interference frequency suppression
Filter mode
1-channel mode
Signal voltage U
(Bridge voltage)
Signal voltage U
(Reference voltage)
Smoothing
Number format
Input diagnosis
Diagnosis: Overflow
Diagnosis: Underflow
Diagnosis: Measuring range overflow
Diagnosis: Measuring range underflow
Diagnosis:
Upper user limit value exceeded
Diagnosis:
Lower user limit value undershot
Upper user limit
Lower user limit
User scaling
User scaling
User scaling
Briefly deviating measured values when resetting!
When resetting to the factory settings, the I/O module indicates
deviating/distorted measured values for a few seconds.
Wait 30 seconds before continuing to operate the I/O module!
12.2

Firmware Update/Downgrade

You can update firmware on the Series 750 I/O Modules with the software
"WAGO I/O-Update 750." The I/O modules can be updated via the service
Manual
Version 1.0.0
d
ref
– Offset
– Gain
750-1491 2AI Resistor Bridge (Strain Gauge)
Standard
50 Hz
fast
Off
±15mV
5 V (internal)
deactivated
Twos Complement
activated
activated
activated
activated
activated
activated
activated
32767
−32768
deactivated
0
16384
WAGO I/O System 750