Inserting And Removing Devices; Inserting The I/O Module; Figure 8: Inserting I/O Module (Example); Figure 9: Snap The I/O Module Into Place (Example) - WAGO 750 Series Manual
I/o system 750 2ai resistor bridge (strain gauge), 2-channel analog input for resistor bridges (strain gauge)
Hide thumbs
Also See for 750 Series:
- Manual (248 pages) ,
- System manual (56 pages) ,
- Instruction manual (46 pages)
Table of Contents
Advertisement
46
Mounting
5.2
Inserting and Removing Devices
5.2.1
Inserting the I/O Module
1.
Position the I/O module in such a way that the groove and spring are
connected to the preceding and following components.
Figure 8: Inserting I/O Module (Example)
2.
Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.
Figure 9: Snap the I/O Module into Place (Example)
3.
Check that the I/O module is seated securely on the carrier rail and in the
assembly. The I/O module must not be inserted crooked or askew.
Manual
Version 1.0.0
750-1491 2AI Resistor Bridge (Strain Gauge)
WAGO I/O System 750
Advertisement
Chapters
Table of Contents
