Input Settings - WAGO 750 Series Manual

62 Commissioning
Table 33: "Common" Menu Item
Parameter
Process image
1-channel mode
Factory setting
*)
The settings are transmitted to the I/O module using the [Write] button.
7.3.2.2

Input Settings

Via the menu items [Input U
parameters of the respective input.
If you change a value, a pencil symbol appears to the left of the respective
parameter and the previously grayed-out menu item [Write] is activated.
Select the [Write] button to save the settings made and transfer them to the I/O
module
Manual
Version 1.0.0
750-1491 2AI Resistor Bridge (Strain Gauge)
Settings / Description
In the standard process image, the
control/status byte is hidden by the head
Standard *)
station and is therefore not visible in the
fieldbus process image.
With the "Extended" setting, the
control/status byte is faded in on the
fieldbus process image. This means that
the diagnostic bits in the status byte can
Extended also be evaluated by a higher-level
controller.
Note: Changing the setting requires a
restart of the node because the process
image changes.
Connection of 1 resistor bridge possible.
In this setting the process data length is
adjusted. There are 2 instead of 4 inputs
available.
The process data length then corresponds
On
to that of the I/O module 750-491, for
example.
Note: Changing the setting requires a restart
of the node because the process image
changes.
Connection of 2 resistor bridges possible.
Off
*)
There are 4 inputs available.
x] and [Input U
d
WAGO I/O System 750
x] you can access the specific
ref