Information Bar; Buttons; Table 31: Buttons - WAGO 750 Series Manual

WAGO I/O System 750
750-1491 2AI Resistor Bridge (Strain Gauge)
7.3.1.2

Information Bar

• Item number: 750-1491
• Item description: 2AI Resistor Bridge (Strain Gauge)
• Version: 01.01.xx(xx)
7.3.1.3

Buttons

Table 31: Buttons

Button Function Explanation
Closes the parameterization dialog.
[Exit]
The connection to the I/O module is interrupted.
[Open]
Opens the dialog for loading a saved parameter file.
Opens the dialog for saving parameterization
[Save]
information in a parameter file.
Reads the current parameterization from the I/O
[Read]
module.
[Write]
Writes the modified parameters to the I/O module.
Resets all I/O module settings to factory settings
Note: The values for the user calibration are also reset
to their default values. Therefore, if you had set your
own values previously, they must be modified again
and written to the I/O module after this reset.
Tip: Make a note of any value settings before resetting
the I/O module.
[Factory
Settings]
Briefly deviating measured values when resetting!
When resetting to the factory settings, the I/O module
indicates deviating/distorted measured values for a few
seconds. Wait 30 seconds before continuing to operate
the I/O module!
[Help] Opens an I/O module help dialog.
Commissioning 59
Manual
Version 1.0.0