Connect Devices; Connecting A Conductor To The Push-In Cage Clamp - WAGO 750 Series Manual

48

Connect Devices

6 Connect Devices
Correct grounding required!
Incorrectly grounded power supply units can distort the measurement signal.
Make sure that the mounting rail and power supply unit(s) are properly
grounded.
6.1 Connecting a Conductor to the Push-in CAGE
CLAMP
The Push-in CAGE CLAMP
finely stranded conductors.
Only connect one conductor to each Push-in CAGE CLAMP
Only one conductor may be connected to each Push-in CAGE CLAMP
connection.
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
Terminate both solid and stranded or ferruled conductors by simply pushing them
in - no tool required. For all other types of conductors, Push-in CAGE CLAMP
must be opened for connection with an operating tool with a 2.5 mm blade (order
no. 210-719).
1. To open the Push-in CAGE CLAMP
opening above the connection.
2. Insert the conductor into the corresponding connection opening.
3. To close the Push-in CAGE CLAMP
conductor is then clamped firmly in place.
Manual
Version 1.0.0
®
connection is appropriate for solid, stranded and
®
750-1491 2AI Resistor Bridge (Strain Gauge)
insert the actuating tool into the
®
simply remove the tool - the
®
WAGO I/O System 750
connection!
®
®
®