Attach Ground Stake To Tnr Upright - KidKraft CASTLEWOOD Installation And Operating Instructions Manual

Step 39: Attach Ground Stake to TNR Upright
A: In the spot shown in fig. 39.1 drive 1 Rebar Ground Stake 13" (330 mm) into the ground against the (8965)
TNR Upright. Be careful not to hit the washer while hammering stake into the ground as this could cause the
washer to break off.
B: Attach the ground stake to (8965) TNR Upright just below the (TN1) T-nut using 1 (S7) Pan Screw as
shown in fig. 39.2.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth
any sharp edges from impact area and touch up with outdoor paint.
Fig. 39.1
Warning! To prevent tipping and avoid potential
injury, stakes must be driven 13" into ground.
Digging or driving stakes can be dangerous if you
do not check first for under-ground wiring, cables
or gas lines.
Hardware
1 x
S7
8965
13" (330 mm)
In Ground
Pan Screw
•See details
77
Fig. 39.2
TN1
S7
Rebar
Ground
Stake
Other Parts
1 x Rebar Ground Stakes