Attach Ground Stake To Tnr Upright; Fort Guides - KidKraft F24930 Installation And Operating Instructions Manual

Step 38: Attach Ground Stake to TNR Upright
A: In the spot shown in fig. 38.1 drive 1 Rebar Ground Stake 13" into the ground against the (8965) TNR
Upright . Be careful not to hit the washer while hammering stake into the ground as this could cause the
washer to break off .
B: Attach the ground stake to (8965) TNR Upright just below the t-nut using 1 (S7) #12 x 2" Pan Screw as
shown in fig. 38.2.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer . Smooth
any sharp edges from impact area and touch up with outdoor paint .
Fig. 38.1
Warning! To prevent tipping and avoid potential
injury, stakes must be driven 13" into ground.
Digging or driving stakes can be dangerous if you
do not check first for under-ground wiring, cables
or gas lines.
Hardware
1 x #12 x 2" Pan Screw
S7
8965
13" In Ground
•See details
78
Fig. 38.2
T-Nut
S7
Rebar
Ground
Stake
Other Parts
1 x Rebar Ground Stakes