Example; Function Key Assignment With The Lokprogrammer - Esu LokSound 5 Installation And Operating Instructions Manual

function outputs

12.3.1. example

Example: AUX4 switch by pressing F9. Suppose you have a LokSound decoder
5 and you would like using the F9 key AUX4, directional independent. AUX4 you
have provided with a bulb.
A look at the "standard mapping LokSound 5" on page 78 shows that the input
block, nothing needs to be changed. F9 is already entered in mapping line 15th
The table in section 12.2.2.2. we see that the AK- tivieren of AUX4 the first CV of
the block to the value of 32 overall continues to be. From the summary table on
page 70, we see also that the CV 481 (Index: 8) needs to be. Therefore must
first CV 32 to value 8, then CV is set to 32 481st
In order for our example to work, the AUX4 output must also be turned on. This
is discussed in Section 12.5. explained. Furthermore, you can see that with F9
usually also the sound slot is switched on. 9 If you do not want to continue with
F9 this sound is played, then proceed as follows: Sound Slot 9 is connected with
the Control CV R, bit 0th Need therefore set the Control CV R the corresponding
mapping line to 0. For mapping line 15 this is the CV 488 (Index:
8th). Therefore must first CV 32 to value 8, then CV is set to 0. 488th

12.4. Function key assignment with the LokProgrammer

Although the programming of the function keys outputs is possible using an ESU
ECoS or with any other DCC-compliant controller, this is much more comfortable
on the PC using the ESU LokProgrammer. Its graphical menu, simplifies the
assignment of functions essential. We recommend the use of the software from
version 5.0.0. To exhaust all possibilities.
Figure 39: Screenshot LokProgrammer, function mapping
77