Procedure For Configuring; Special Functions 1 And 2 - Esu LokSound 5 Installation And Operating Instructions Manual

function outputs
Driving ROCO®. Also in connection with auto- matic arrival and prints.
• Panto: This function is required for ESU locomotives funktionsfä- higem
pantograph.
• Power Pack Control: Controls the charging and discharging of the exter- nal
power pack. Must be selected when a Power Pack is connected. Note also
Section 6.12.2.

12.5.2 procedure for configuring

To configure a function output correctly, proceed as follows:
1. Write down the value for "Mode Select" from the table on page 82nd
2. Calculate. The value for the special functions CV 1 by ad- decode the values
​ ​ o f the desired functions from the table
3. Select a brightness value.
4. Write the values ​ ​ i n the respective control CVs. Repeat this procedure for all
function outputs. Example: Double Strobe with LEDs on AUX4 for LokSound
de- coder 5.
We want to create a Double strobe output to AUX4 which is wired with an LED.
1. learn from the table on page 82, we assume that the Mode Select CV must be set
to the sixth
2. We see that for LED compensation mode CV must have Value 128th
3. Have a brightness value of the 25th
4. From the table on page 79, we see that the Mode Select CV for AUX4 299th
We set CV 299 = 4. We also find out that the brightness CV is 302 and set it
to 25. Finally, the Special function CV for AUX4 (303) to the value of the
128th
Please set the index register CV 31 to 16 and CV 32 to 0 before changing
values.

12.5.2.1. Special functions 1 and 2

Depending on the light effect, it may be necessary to configure the spe- cial
functions CV 1 in more detail. The following options are available:
• Phase exchange: You can choose whether the start of blinking is to be offset by
180 degrees with blinking lights. So that you can realize a double flashlight.
• Grade Crossing: If set, the output will only be active when the global function
"Grade Crossing" is active AND the corresponding function key is active. One
can prove this globalization le function with another key and thus achieve
various effects. Grade Crossing can be used with most light functions.
• Rule 17 Forward: Applicable in combination with "Dimmable headlight" or
"Dimmable light with on / Fade Out". Results in a dimmed to 60% light when the
locomotive has stopped. When the engine is running forward, the brightness is
increased to 100%.
• Rule 17 Reverse: Like Rule 17 Forward, but the brightness is increased to 100%
when the locomotive runs in reverse.
• Dimmer (Fade Out): The brightness is maintained at 60%, as long as is active
the global function "Dimmer". With this function, you can easily realize a high
beam, by setting a function key, the global function "Dimmer" (see. Section
12.5.1.)
81