Esu LokSound 5 Installation And Operating Instructions Manual page 67

motor control
CV
CV 257
CV 273
CV 289
CV 305
Alternatively, you can also use the LokProgrammer to activate AUX4 in stance
as well as while driving in both directions, as shown in Figure 38th
Figure 38: Settings for C-Sinus
Furthermore, the serial interface (SUSI) has for some models are enabled
because the built-in control electronics there lacked their stuffing here over so
you erhält.Schalten SUSI by setting 124-bit 3 in CV. Starting from the value
value of CV 124 (20), you should write to the value CV124 28th Unfortunately,
there is another obstacle: the C-Sinussteuer- motherboard draws (too much)
energy from the sound decoders. If you have activated Railcom at your office, or
stretch Marklin brake installed, it can therefore men com- malfunction. therefore
Connect a capacitor with about 47 uF be- tween U + and decoder ground as
described in section 12.6. shown.
value
48
48
48
48
67