Physical Outputs; Logic Functions - Esu LokSound 5 Installation And Operating Instructions Manual

function outputs
12.2.2.2. Physical function outputs
Physical function outputs are actually present at the decoder outputs, where real
(by wires) consumers can be connected. Which outputs actually own the
individual decoder, is clearly illustrated in Table on page 36th
You can assign all available outputs in the function key assignment because
other outputs nen on external Zusatzplati- (eg ESU I / O expansion board) may
be present. These are fully integrated into the function key assignment. The
block for the physical mapping outputs of each row comprises three CVs. The
importance of these CVs is as follows:
description
Surname
An output light Front [Conf. 1]
Control CV K
Output light back to [Conf. 1]
AUX1 On [Conf 1]
Output AUX2 On [Conf 1]
At output AUX3
At output AUX4
An output AUX5
At output AUX6
At output AUX7
Control CV L
At output AUX8
At output AUX9
At output AUX10
At output AUX11
At output AUX12
At output AUX13
At output AUX14
Control CV M output AUX15 On
At output AUX16
At output AUX17
At output AUX18
An output light Front [Conf. 2]
Output light back to [Conf. 2]
AUX1 On [Conf 2.]
Output AUX2 [2. Conf] to
74
For each output you want to turn on, you have to add the appropriate value for
the controlling CV. Which CV must be written exactly please see again the
summary table on page 70. For the mapping line 1, these are for example the
CVs 257 (Control CV K) CV 258 (Contrl CV L) and CV 259 (Control CV M).
Note that this CV numbers were used dingungsblock even for the loading
(Control CV A, B, C), but on a different page (value of CV 16 is different) are
located. Always ensure that the correct value of CV 16 before writing!
value
The light outputs of the front and rear as well as the output AUX1 and AUX2 are
1
each present twice. These outputs kön- NEN assume two configurations
2
(configuration [1] and configuration of [2]). You can determine assignment by
4
pressing a key in the function key, which of the two Ausgangskonfiguratio- NEN
8th
should be active. Thus, for example, featured a possible high beam. For more
16
information see the chapter 12.5.1.
32
64
128
1

12.2.2.3. logic functions

2
Under Logifunktionen functions are combined, the di- rectly or indirectly
4
"dynamic" also will influence behavior of the decoder. Often these functions are
8th effective only in conjunction with other settings.
16
32
Do not confuse logic functions with logic outputs. kausgänge logical are
64
physical function outputs, while logic functions are software-controlled additional
128
functions. The following functions are provided:
1
2
4
• Drive Hold: Makes the Gechwindigkeit constant. Controller changes only affect
the sound, not the real speed
8th
16
32
•
Clutch Waltz: The locomotive is automatically press and disarmament CKEN as
64
described in Section 12.5.7. shown.
128