Accessories; Change Over; Hamo Magnets; Cable Sets With 8-Pin. Or 6-Pol. Socket - Esu LokSound 5 Installation And Operating Instructions Manual

equipment

19. Accessories

You can ask your dealer for professional or on our website for details on the
accessories.

19.1. change over

The shoe changeover board 51966 only for decoders with 21MTC is installed in
locomotives with two grinders. In order to switch the forward pickup forward
imagewise - ideal for block control!

19.2. HAMO Magnets

The motors in many Märklin® models universal motors not kön- nen are directly
controlled by sound decoders. You must first replace the field coil of these
motors mag- nets by a perma-. ESU following magnets are available: 51960
Permanent magnet such as 220560, for anchor 217450, D = 24.5mm, for
engine plates 216730, 211990, 228500
51961
Permanent magnet such as 220450, for anchor 200680, D = 18.0
mm, for motor shield 204900
51962 Permanent magnet such as 235690, for anchor 231440, D =
19.1mm, for motor shield 231350
51965 Permanent magnet, for Marklin 3015, ET800, ST800, lane 1 universal motors
19.3. Cable sets with 8-pin. or 6-pol. Rifle
If the re-build locomotive has no digital interface, but you do not want to cut the
interface connector of the decoder so help our cable sets 51950 or 51951: First
install an appropriate harness and then plug the decoder simply a.

19.4. adapter boards

Would you like to retrofit with 21MTC a locomotive with a sound decoders, to
offer our adapter board 51967 at This on the one hand provides a pedestal on
the choice of the sound can be easily aufgestelt, on the other hand soldering
points on which the original wiring of the locomotive can be attached. ideal
94
for digitizing Märklin® locomotives. Under the number 51968 and 51957 an
adapter board is available which the two outputs AUX3 amplified to AUX10
transistor means and thereby makes it accessible. Ideal for complex
conversions!
Under the number 51958 is an adapter board for PluX22 ER hältlich.