Motorola® Address; Subsequent Addresses For More Features; Addresses In M4 Operation - Esu LokSound 5 Installation And Operating Instructions Manual

Program
9.3. Motorola® address
LokSound decoders can be operated in the Motorola® format. The address used
for this mode is stored in CV1.
The address is the short address DCC in Section 9.1. identical. So the sound
decoders hear both the DCC and in Motorola® mode at the same address. The
possible values ​ ​ c hen spaces in 7.2.2.2. listed.
Märklin® digital device (6020, 6021, Delta®) can only use addresses used to 80
wt. If you have set a higher value in CV1, you will not be able to control the train
with these centers.

9.3.1. Subsequent addresses for more features

In Advanced Motorola® format in addition to the light (F0) were - function only
the functions F1 to F4 are provided. This is certainly for the many functions of
the LokSound 5 far too little. Therefore, it is possible any decoder up to 3
additional (a total of
to give 4) addresses. These so-called subsequent addresses Schliemann, the
actual stored in CV1 address SEN and only serve to trigger functions. The motor
control is done solely via the base address (CV1).
Example: You select the address of a BR 50 50 in CV 1. You want three
subsequent addresses. These are then 51, 52 and 53. Then turn the following
functions when you enter the addresses on your 6021:
Surname
base address
Follow Address 1
Follow Address 2
Follow address 3
54
example address features
50 F0, F1 - F4
F5 - F8
51 (50 + 1)
F9 - F12
52 (50 + 2)
F13 - F16
53 (50 + 3)
Make sure that the sequence of addresses to another vehicle are occupied.
Otherwise, you'll inadvertently control multiple vehicles!
The result addresses are enabled by using the CV 49th Responsible bits 3 and
7. For compatibility reasons, are not lying this together. The relationship is as
follows:
Bit 7 Bit 3 Meaning
no follow-address
0 0
Next address 1 is active
0 1
Result address 2 active
1 0
1 1
Follow address three active
Read to enable the subsequent addresses initially the value of CV 49 (ex works:
CV 49 = 1) and add add the value shown in the column. 4 To activate, for
example, three subsequent addresses, so you need to CV 49 with a value of 136
+ 1 = describe 137th
Subsequent addresses are only active in Motorola® mode.

9.4. Addresses in M4 operation

Also, in a mfx® (compatible) system addresses are used for addressing a
locomotive. However, these are allocated automatically when the decoder from
the central unit. The addresses can be either manually entered even more user
read out from loading.
Value that must be added to
CV 49
0
8th
128
136