Short Mode; Long Mode; Programming With Märklin® Mobile Station ® 1 - Esu LokSound 5 Installation And Operating Instructions Manual

Program
voltage is switched off Enter the current Decoderad- ress one. Do not know the
address, enter "80".
• Press the Power Reversal on speed controller (speed controller to the left
beyond the stop turn until you hear a click), hold the knob and then press the
"Go" button. Please note that the 6021/6020 only permits you to enter the
Values ​ ​ 0 1 to 80 wt. A value of 0 is missing. Instead of "0" must always be
entered "80".

8.2.3.2. short mode

The decoder is in the short mode (the headlights flash periodically in brief
intervals).
• Now enter the number of the CV that you möch- change th, eg 01 (two digits).
• For confirmation activate the Power Reversal (Now the lighting flashes twice
briefly).
• Now enter the new value for the CV, eg: 15 (two digits).
• Confirm by reversing press (about 1 second illumination lights continuously for
confirmation).
• You can now enter other CVs you want to change.
• The programming mode (press "Stop" button on the 6021, then "Go" button) "80"
or power cycle the track voltage by selecting CV.

8.2.3.3. long mode

The long mode can be reached by writing the short mode in CV 07 the value
07th The decoder acknowledges the alternating sel in the long mode by slowly
flashing lights.
• Now enter the hundreds and tens digit in CV, you want to change. Example: You
want to CV 124 change, so enter here "12".
• Confirm by reversing press (Now the lighting flashes long, short, periodic).
• Now enter double digits the ones digit of the CV. (In our example: "04").
50
• press the Power Reversal to confirm. Now the decoder expects the entry of the
CV value. The lighting flashes Long, short, short (periodic)
• Enter (two digits) then the hundreds and tens digit of the new CV value one.
(Example: You want the value to be written 135 so enter "13" a..)
• press the Power Reversal to confirm. Now the lights will flash Long, short, short,
short (periodic)
• Now enter (two digits), the unit of the new CV value (in the example: "05")
• Confirm by reversing press (about 1 second illumination lights continuously for
confirmation).
• You can now enter other CVs in long mode, you want to change.
• The long mode by power cycling the rail voltage (press "Stop" button on the
6021, then How-the "Go" button) to leave.
8.2.4. Programming with Märklin® Mobile Station ® 1
Even with the original Mobile Station ® 1 (60562) can be changed some CVs of
the decoder. For this, the general will use my register programming menu. only
the CVs 1 can be changed to 80 as in the 6021, the possible values ​ ​ f or the CVs
are also limited to the range of 1 to 80 wt.
The programming menu is in the locomotive menu Mobile station® only for
certain locomotives available, which must be created from the database. It must
be a locomotive that is programmable. To change, proceed as follows:
• Create a new locomotive from the database. The exact superiors hens as you
read the manual for the Mobile Station ®:
• Select Lok 36,330th The display shows the locomotive Ee 3/3 is to actively look.
• By pressing the "MENU / ESC" button, you can now under the