Esu LokSound 5 Installation And Operating Instructions Manual page 101

List of all supported CVs
CV
Surname
Time for twinkling effects
112
113 Power Fail Bypass
116
EMF measurement period (sampling rate) at
Vmin
117 EMF measurement period (sample) at
Vmax
118
Length of the blanking interval of the back emf
voltage at VMin
119
Length of the blanking interval of the back emf
voltage at Vmax
123 ABC Mode "slowly"
Advanced Configuration # 2
124
description
Blinking frequency of the strobe effects.
Always a multiple of 0.065536 seconds. See. Section 12.5.4.
Time, which bridges the decoder after a power interruption from the power pack. Unit:
multiple of 0.016384 seconds. See 6.12.2.
Frequency of the EMF measurement in 0.1 milliseconds at speed level 1
Frequency of the EMF measurement in 0.1 milliseconds at speed level 255
Length of the measurement gap in 0.1 milliseconds at speed level 1
Length of the measurement gap in 0.1 milliseconds at speed level 255
Rate that applies to ABC braking in slow travel section
Other important settings of the decoder
description
bit
Wrong-: Maintain direction when changing direction.
0
not maintain direction
Decoderlock means CV 15/16 off Decoderlock means
1
CV 15/16 switched
Starting delay off switch starting delay
2
Serial protocol for C-Sinus off serial protocol for
3
C-Sinus switched
AUX9 output is active (only LokSound 5 H0) input wheel sensor is
4
turned on (only LokSound 5 H0)
5 Motor protection in blocking
The engine is not switched off at blocking the engine is
turned off a few seconds for blocking to avoid burnout
Reserved
6
Reserved
7
range value
0 - 255 20
0 - 255 32
50-200 50
50-200150
10-20150
10 - 20 15
0-255100
- 21
value
1
0
02
04
08
0
16
0
32
64
128
101