Analog Operation; Analog Dc Operation; Analog Ac Operation - Esu LokSound 5 Installation And Operating Instructions Manual

commissioning
receives time (4 seconds) no mfx® more data. The Deco responds to data
packets after a certain priority:
• The top priority DCC with RailComPlus®. the decoder is therefore always log on
with RailComPlus® and DCC, although M4 is active to an ESU ECoS.
• If no RailComPlus® exists, will be treated as priority 2 M4. At Marklin Central
Station ® centers, the decoder is therefore log on with M4.
• The "ordinary" DCC is at the same level as Motorola®
• Lowest priority Selectrix®.
Not data protocols needed to be shut down. Section 9.5. provides information.

7.3. analog operation

Ex works LokSound decoders are set Analogan- were used.
Also note the information in Section 10.3. when the de- coder back during
operation between analogue into digital sectors and back.
7.3.1. Analogue DC operation
LokSound decoders can be used on conventional equipment under direct current.
However, the load control is active here at the factory. So you can control your
locomotives precisely and drive extremely slow in DC operation. However, since
the load regulation about 3 - 4 volts "reserve" is required, you must, before the
locomotive starts moving the transformer turn up something more than
locomotives without decoder.
7.3.2. Analogue AC Operation
Where provided sound decoders offer support operation with AC transformers.
He can replace an analog Umschaltmo- dul problems. As in DC operation, the
load regulation is in AC mode active and ensures th a fine fühliges taxes and
unprecedented Langsamfahreigenschaf-. The pulse for changing direction
reversal is recognized by the LokSound as usual, however, wait until the
locomotive
46
has stopped prior to changing direction. Never give a moving locomotive a
switching command! could be damaged gears!
We can not recommend the use of old blue Märklin® transformers that were
originally designed for 220 Volt. Depending on age and tolerance of these
transformers in conjunction with the fluctuations of your power supply
network, the output from BE WAIVED changing direction could be so high that
the sound decoders is destroyed.
Do yourself and your locomotives a favor and purchase your advertising to
reward you with a longer life Märklin® transformer No.. 6647 locomotives and
decoders!