Connection Scheme Loksound 5 Xl Decoder; Following Lgb Transmission - Esu LokSound 5 Installation And Operating Instructions Manual

Wiring diagram LokSound 5 XL
6.8.3. Wiring diagram LokSound XL decoders 5
Left track connection right
track connection
Right track connection (alternative)
output right
Motor output left engine
DC motor
Speaker 1
Speaker 1
Speaker 1 4 ~ 16
ohms
Figure 12: Wiring pattern 5 LokSound XL (Example wiring)
6.8.3.1. Following LGB Gear
With the LGB interface cable, the receiver can be connected directly to the
appropriate LGB locomotives. It can of installing the Mo and light functions are
controlled. The cable is available under item number 55026 in the LGB
assortment. Remove the Falststecker the interface cable and screw the
Speaker 2 (4 ~ 16 ohms)
U + (+ pole) +
U (+ pole)
GND
wheel sensor
Servo1
Servo4
Servo2 Servo3
(Stripped) ends in the terminals of the decoder. Set the DIP switches on the
interface according to LGB manual.
Non-compliance can lead to the destruction of the decoder!
Light rear light
front
SENSOR1
AUX1 AUX2
AUX3
SENSOR2
AUX4 AUX5
(reserved)
AUX6 U + OFF
27