Settings For Analogue Mode; Lgb® Chain Control; Swiss Headlight Mode - Esu LokSound 5 Installation And Operating Instructions Manual

function outputs

12.7. Settings for analogue mode

Using the two CVs 13 and 14 can be determined WEL surface of the function
keys are switched in analog mode. One can thus "simulate" pressing an F-key
quasi. From the factory, the CVs are initially set up on the directional headlights
(F0!) And F1 (ex works allocated to AUX1) is on.
Analog Control Function 1 CV #
F1 F2
13
1 2
Analog Control Function 2 CV #
F0 F9
14
1 2
12.8. LGB® chain control
For operation on LGB-panels or the ROCO® Lokmaus I can be switched to
pulse train control. You must put in CV49 bit. 5 Out of the decoder counts the
number of F1 button is pressed to activate the desired function. To follow all the
function keys can be achieved by clocking the F1 key.
12.9. Swiss light change
With the help of the ESU mappings can be many ways taping REA. A good
example is the Swiss light change. For this, a third lamp circuit is required, which
always turned on the lamp at the bottom left of the Triple headlights and signal
when the lights are turned on. This third circuit to be switched regardless of the
direction of travel. Figure 41 shows a possible wiring of this arrangement, the
output AUX1 (green cable) for the third current circuit is used. It must now "only"
the decoder in such that this circuit should always be turned when the light
button is pressed.
86
F3 F4 F5 F6
16 32
4 8th
F10 F11 F12 F13 F15 F15
16 32
4 8th
This in the variable CV 330 the value of 5 as well as in CV 346, the value 6 is
entered. (Do not forget to firstly set the index register CV 31 to set value 16 and
CV 32 to value 2!). That's it.
lamps behind
yellow
F8
F7
128
64
= Light On =
128
64
Light off
lamps front
White
green
Figure 40: Swiss headlight mode