Motorola® Mode; Speed Steps; Extended Motorola® Address Range; Selectrix® Operating - Esu LokSound 5 Installation And Operating Instructions Manual

commissioning
When operating with Lenz® digital plus V3.0 does not recognize planning if you
want to go with 14 speed steps. Verwen- you here 28/128 speed steps.
Each time the LokSound receives power (ie after switching on the system) and
the light is switched on, it attempts to recognize the number of speed steps. For
this, the light must be turned on and turned until the speed control knob until the
light is on permanently.
Turn off during operation, the speed steps, so you have to make the decoder off
power, so the automatic operating as desired.
This auto-detect 49 can be switched off by means of bit 4 CV (see CV table in
Chapter 21.1), if this does not lead to the desired result. But then bit the correct
driving position must be CV29, 5 are set.
7.2.2. Motorola® operation
The LokSound can be used with all previous Märklin® devices or compatible
systems. The functions F1 to F4 can only called by. "new Motorola® format" are
used. To enable this, at the 6021 DIP switch 2 to the upper position ( "On") must
be submitted.
LokSound decoders support two special features in Motorola® mode:
7.2.2.1. 28 steps
While the original Märklin® of the Central 6021, Delta® and Mobile Station ®
Motorola® system only supports 14 speed steps sound decoders also dominate
the 28-speed step mode. This leads, in conjunction with appropriately equipped
stations (eg ECoS, setting "Motorola 28") to smoother control of driving behavior.
Attitudes gen for this mode are the decoder side not to hit.
7.2.2.2. Extended Motorola® Address Range
While the original Motorola® format only knows the addresses from 01 to 80,
offer sound decoders following range of addresses: LokSound 5
In Chapter 9, the address setting is described in detail. It also describes how
more than four functions can be switched by means of secondary addresses.
7.2.3. Selectrix® operation
You can drive LokSound with every Selectrix® compatible cen- rale and turn the
function light and F1. To change of decoder parameters the DCC program- ming
must be used. Programming with "pure" Selectrix® systems is not possible.
There, struck attitudes gen are also valid for operation with Selectrix® centers.
Once the decoder with Motorola®, M4 or DCC is addressed (ie a specific
package for Him receives), the Selectrix® receiver switches off automatically.
This one problemlo- ser mixed operation Selectrix® / DCC / Motorola / M4 is
guaranteed. The Selectrix® receiver turns on again as soon as the de- coder
was taken briefly energized.
7.2.4. M4-operation
Where provided, sound decoders of the Märklin®- systems devices Central
Station, Central station 2 and mobile station according to the re-railing are
automatically detected and incorporated into the system. The procedure is fully
automatic settings are not required.
When the decoder receives a valid mfx® compatible data packet with (the
decoder so at a mfx® compatible panel is exaggerated be-), it will ignore any
Motorola, Selectrix also DCC data packets.
Other data packets, the decoder will accept again only if it has been taken off
power or for a certain
01 - 255,
45