Using Logic Outputs; Power Outputs; Servo Outputs Loksound 5 L - Esu LokSound 5 Installation And Operating Instructions Manual

Installing the decoder
Voltage is about 1.5V lower than the track voltage. The blue wire is the
"plus-pole", the functions relating gang even the "negative".
Are light emitting diodes (LEDs) to the function outputs CONNECTED sen (see.
Fig. 26), must be strictly a series resistor to be built once. This should be
between 470 ohms and 2.2kOhm Lie gen. Operation without a series resistor will
destroy the LED!
b) The lamps / functions (collectively switched) se against the Lokmas- (eg
almost all Märklin® locomotives and older Fleischmann® and ROCO®).
The wiring is simpler, the resulting voltage at the bulb but also by about half
lower. This type of connection is not suitable for multi-protocol operation: Both
M4 and Motorola® packets are asymmetrical. DA ago are not supplied for a
certain time the function outputs with power. This results in a rhythmic Lichtfla-
thickeners (pulsing) that is clearly visible in particular in LEDs. In analogue mode
works in this Anschlus- also sart the light only in one direction. What this is
depends on how the locomotive is rerailed.
• The reverse headlights are soldered to the yellow wire, the front headlights to
the white wire.
If your locomotive on the variant b) be interconnected, the arrival is closing
completely. Otherwise, you must connect the remaining all bulbs and functions
together to the blue cable. This may not have any connection to the chassis!
Even a "mixed mode" is allowed.

6.10.5. Using logic outputs

Of logic outputs directly consumers can not be operated. It must be connected
external power transistors. Usually this on the Lokplatinen already present
(where necessary).
For "home builder" ESU offers under the numbers 51957 and 51968 to the
appropriate adapter boards with transistors.
38

6.10.6. Power outputs

LokSound 5 decoder can drive up to 6 servos. It kön- nen all RC servos are
used with positive momentum. We recommend digital servos, as they do not
flinch at power generally. Before you can use the servos, the outputs must be
switched to the "power". Each servo output can be configured as a normal logic
output and used. Section 12.2.2.3 explains how.

6.10.6.1 servo outputs LokSound 5 L

The LokSound 5 L offers 4 on servo outputs. The servos must be connected
appropriately to the adapter board. Servo3 and Servo4 can be soldered apter as
shown in Figure 27 on the ad for which Servo5 and Servo6 the connection is
made to the SUSI pins, as shown in Fig. 11.
Figure 27: RC servos to LokSound 5 L
IMP
+ 5V
(AUX18)
Servo4
IMP
(AUX17)
GND
Servo3
+ 5V
GND