Esu LokSound 5 Installation And Operating Instructions Manual page 69

function outputs
• In the output block is fixed, what should happen if the condition (s) is satisfied /
are. This may be the switching of a function output, or sound is turned on. The
table always has exactly 72 entries, so-called "mapping lines". The decoder
works constantly this table from top to bottom (lines 1 to 72), and checks for
each mapping line, whether the conditions of the "conditional block" are met.
ONLY then the decoder considers the desired actions in the output block and
executes them. He then moves to the next row and begins at the end again from
the top. This happens hundreds of times per second.
The conditions of each block are stored in CVs. Pro Map- pingzeile 10 CVs for
the conditional block and 10 CVs for the output block are reserved. In the table
on page 70, the charge of the respective mapping line CVs are indicated.
Hereinafter, these CVs from "A" to "T" are numbered and are referred to as
Control CV's.
Since all CVs involved are in the index range, of each PAS send value for CV 32
mitangegeben same. Before you edit one of the CVs, you should make sure that
the index CV 31 to 16, the CV was programmed to the value shown 32nd Note
that the values ​ ​ f or CV 32 for the conditional block and the output block are
different.
69