Esu LokSound 5 Installation And Operating Instructions Manual page 73

function outputs
Control CV I Press F30 to F30 key
is Off
F31 key is to key F31
is Off
Wheel sensor is On wheel
sensor is Off
reserved
reserved
Control CV J Sensor 1 is On
Sensor 1 is Off
Sensor 2 is On sensor
2 is Off
Sensor 3 is at sensor
3 is Off
Sensor 4 is at sensor
4 is Off
The value to be written into each of Control CVs is easy to identify: Add the
numerical values ​ ​ o f the desired conditions.
Example: You want the F0 key is to be one and the locomotive should be
forward, but F4 should be off. They therefore write to the Control CV A is 4 + 16
= 20 and the Control CV B equals 32. All other CVs remain 0. Thus the
conditions are ignored. In Which CV you need to write the values ​ ​ t hat you can
see from the previous table. The input block for the first mapping line is between
257 CV (Control CV A) and 266 CV (Control CV J).
The LokSound 5 family supports up to 5 sensor inputs. Depending on the
decoder, however, are not always all inputs existing to, and sometimes need to
be activated by software. Working watch the Table 5.1.6.
Still, you can decoders 5 softwaresei- tig all outputs mapped because on add-in
boards (eg in our Lokmodellen the ESU Engineering Edition) existing these
sensors may be the all LokSound.
12
48
16
32
64
128
12
48
16
32
64
128
73