To Remove The Floppy Disk Drive - Nortel CallPilot 703t Maintenance And Diagnostics

Replacing media drives

To remove the floppy disk drive

ATTENTION
.
.
1 Prepare the server for floppy disk drive replacement as follows:
a. Shut down the server, and then disconnect the power and
b. Remove the side cover.
c. Remove the upper fan holder foam.
For instructions, see "Preparing the server for hardware
maintenance" on page 120.
.
2 Disconnect the power and signal cables of the disk drive.
166
Nortel recommends that you use a magnetic screwdriver in
this procedure. A nonmagnetic screwdriver can result in
screws being lost between the chassis and plastic bezel.
CAUTION
Risk of data loss
Keep magnetic screwdrivers away from hard drives, floppy
disks, and backup tapes to prevent data loss.
CAUTION
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.
peripheral device cables.
WARNING
Risk of personal injury or equipment damage
Failure to follow the procedures in "Preparing the
server for hardware maintenance" on page 120 can
result in electrical shock or equipment damage.
Standard 1.06
CallPilot