Nortel CallPilot 703t Maintenance And Diagnostics page 54

Using Windows online diagnostic tools
The ping command
The ping command sends an echo request to a specified host. Use this
command to verify network connectivity to the remote device.
Ping command syntax
The ping command uses the following syntax:
ping [-t] [-a] [-n count] [-l size] [-f] [-i TTL]
Table 5: Ping command parameters
Parameter
-t
-a
-n count
-l size
-f
-i TTL
-v TOS
-r count
-s count
-j host-list
-k host-list
-w timeout
54
[-v TOS] [-r count] [-s count]
[[-j host-list] | [-k host-list]]
[-w timeout] destination-list
Description
Pings the specified host until interrupted.
Resolves addresses to host names.
Specifies the number of echo requests to send.
Sends buffer size.
Sets Don't Fragment flag in packet.
Sets Time-To-Live
Sets Type Of Service
Records route for count hops
Shows time stamp for count hops
Shows loose source route along host list
Shows strict source route along host list
Sets time-out in milliseconds to wait for each reply
Standard 1.06
CallPilot