Nortel CallPilot 703t Maintenance And Diagnostics page 26

Troubleshooting your CallPilot system
The server LEDs, from top to bottom and left to right, indicate the status
of the following:
the ELAN and CLAN network interfaces
hard drive
power/sleep
system
LEDs are also provided on the SCSI tape drive faceplate, floppy disk
drive faceplate, and the IDE CD-ROM drive faceplate.
Network LED states
The network LEDs are green and are located as follows:
LED
position
Left
Right
IF the network
interface LED is
off
26
Controller
name
NIC1
NIC2
THEN
a valid hardware connection with the network has
not been established.
Ensure that the Ethernet cable is connected to
both the Ethernet connector on the server and the
respective network hub. If the cable is connected,
ensure that the cable is serviceable.
Controller
type
10/100Base-T
10/100/1000Base-T
Standard 1.06
LAN
type
ELAN
CLAN
CallPilot