RAID operations
Result: The system should display both SCSI channels, each
having one drive. SCSI IDs should be 0 for each channel. All disk
drives should be in READY state.
Note: Do not use the Load command on the Configure menu. This
command is not for RAID operations.
12
Create the first logical drive by selecting Channel-1 ID 0 (A01-01),
and pressing the Spacebar. The display will change to ONLIN A01-
01. Select Channel-2 ID-0 (A01-02) and again press the Spacebar.
Result: After selection, the drives will blink.
13
Press Enter to End the Array.
Result: The blinking stops.
14
Press F10 to configure the logical drive.
15
Press the space bar to select Configuration Array.
Result: Span-1 appears in the box opened for the A01 logical drive.
16
Press F10 to configure the logical drives.Then press the space bar
to select configuration array.
Result: Span-1 appears in the box opened for the A01 logical drive.
Configure the logical drives by pressing F10 again.
Result: The system prompts you for each of the logical drives to
consecutively select:
RAID 1;
Size: accept the size displayed
Advanced Menu
Accept
SPAN = NO
Change the last value to NOSPAN if required.
17
Highlight Accept and press Enter twice to accept these new values.
Result: The system prompts you to save the configuration.
18
Highlight YES and press Enter.
19
Press ESC twice to exit the submenus.
178
Standard 1.06
CallPilot