Nortel CallPilot 703t Maintenance And Diagnostics page 104

Using CallPilot Manager to monitor hardware
3 Do one of the following:
IF you want to stop or start
all of the channels
associated with a link
only one or several
channels that are
associated with a link
4 Click Courtesy Stop, Stop, or Start, as required.
Result: If you clicked Courtesy Stop or Stop, you are asked to
confirm the Courtesy Stop or Stop. Click OK.
The selected channels change to idle or on-duty status, according
to the action you chose.
If the buttons are not available, wait a few seconds for the screen to
refresh:
104
The Courtesy Stop and Stop buttons are available only when a
component is in one of the following states: Idle, Active, Remote
Alarm, Local Alarms.
THEN
check the check box to the left of
the link that you want to stop or
start.
Repeat this step for each link.
check the check box for each
channel that you want to stop or
start.
Standard 1.06
CallPilot