To Investigate Server Boot Problems; What To Do When The Server Fails To Boot Into Service - Nortel CallPilot 703t Maintenance And Diagnostics
Hide thumbs
Also See for CallPilot 703t:
- Installation and configuration manual (312 pages) ,
- Hardware installation (72 pages) ,
- User manual (182 pages)
Table of Contents
Advertisement
January 2007
What to do when the server fails to boot
into service
The following sections suggest tasks you can perform to determine why
the 703t server fails the bootup cycle.
To investigate server boot problems
1
Ensure that you accurately record any diagnostic codes and error
messages that occur.
2
Try restarting the server by pressing the power button on the server.
3
During the boot sequence, view the diagnostic codes on the monitor
for failures.
Note: Allow 5 minutes for the boot cycle to complete.
4
If errors indicate a hardware problem with a failure to boot to the
operating system or if the server boots to the operating system, but
fails to boot into CallPilot, refer to the Troubleshooting Guide
7101-501)
5
If you still cannot find the cause of the boot failure after performing
the tasks described in the following sections, call your Nortel
technical support representative.
703t Server Maintenance and Diagnostics
.
Troubleshooting your CallPilot system
(555-
41
Advertisement
Table of Contents
