To Install A Replacement Cd-Rom Drive - Nortel CallPilot 703t Maintenance And Diagnostics

January 2007
7 Place the drive in an antistatic protective wrapper.
8 Continue with "To install a replacement CD-ROM drive" on
page 163".

To install a replacement CD-ROM drive

.
1 Remove the new CD-ROM drive from its protective wrapper, and
place it on an antistatic surface.
2 Record the drive model and serial numbers in your equipment log.
3 Set the new CD-ROM drive to IDE Master by changing the jumper
settings at the back of the drive.
Note: Refer to the CD-ROM drive manufacturer's documentation
for specific jumper settings.
4 Install the slide rails on the new drive.
Ensure that the first set of holes on the bracket are aligned with the
screw holes closest to the front of the CD-ROM drive.
5 Slide the new CD-ROM drive into the drive bay and secure it to the
front of the server with the screws you removed earlier.
6 Reconnect the CD-ROM drive's IDE cable to IDE0 (blue connector)
on the motherboard. Ensure that the blue stripe on the cable at the
motherboard connector end faces towards the back of the server.
ATTENTION
For more information, see the "Cabling diagram" on page 146.
7 Reconnect the CD-ROM drive's power cable.
703t Server Maintenance and Diagnostics
CAUTION
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.
The server will not start if the cable is connected
backwards.
Replacing media drives
163