To Configure The Bios - Nortel CallPilot 703t Maintenance And Diagnostics

Working with the CallPilot server BIOS
5 While the server is restarting, remove the BIOS update disk from
the server's floppy disk drive.
6 When the server has rebooted, continue with "To configure the
BIOS" on page 224.

To configure the BIOS

Note: Only options that need to be changed from their defaults are
described below. As you perform this procedure, you should still
validate that all BIOS settings conform to the values listed in "BIOS
settings," on page 217.
1 During the server startup and while the startup diagnostics still
appear on the screen, press F2 to display the Main menu screen.
2 Press BIOS Default (F9) to load the default BIOS settings.
Result: You are prompted to confirm the settings.
3 Choose Yes, and then press Enter.
Result: The Main menu reappears.
4 Use the right and left arrow keys to choose the Advanced screen.
Result: A list of configuration sections appears.
5 Configure the sections as follows:
6 Use the right and left arrow keys to choose the Server screen.
Result: A list of configuration sections appears.
7 Configure the sections as follows:
8 Use the right and left arrow keys to choose the Boot screen.
224
Boot-up Diag Screen: Enabled
Num Lock: ON
Sleep Button: Disabled
Assert NMI on PERR: Disabled
Assert NMI on SERR: Disabled
Standard 1.06
CallPilot