Installation; Pre-Installation Check - Emerson PACSystems RX3i User Manual

RSTI-EP PROFINET I/O Controller User Manual
GFK-2571R
Section 2:
This Section provides instructions for installing PACSystems RX3i PROFINET Controller
modules.
•

Pre-Installation check

• Removing the backplane knockout
• Module installation and removal
• Hot insertion and removal
• Port connections
• Installing SFP devices
• LED indications
• Installing the USB Port Driver
• Firmware updates
• Time synchronization with RX3i CPU
For additional information about system installation, also refer to the PACSystems RX3i
Systems Manual, GFK-2314.
2.1 Pre-Installation Check
Upon receiving your RX3i equipment, carefully inspect all shipping containers for damage.
If any part of the system is damaged, notify the carrier immediately. The damaged shipping
container should be saved as evidence for inspection by the carrier.
As the consignee, it is your responsibility to register a claim with the carrier for damage
incurred during shipment. However, Emerson will fully cooperate with you, should such
action be necessary.
After unpacking the RX3i equipment, record all serial numbers. Serial numbers are required
if you should need to contact Customer Care during the warranty period. All shipping
containers and all packing material should be saved should it be necessary to transport or
ship any part of the system.
Verify that all components of the system have been received and that they agree with your
order. If the system received does not agree with your order, contact Customer Care.
If you need technical help, contact Technical Support. For phone numbers and email
addresses, see the Contact Information page in the front of this manual.

Installation

Installation
Section 2
May 2021
29