Emerson PACSystems RX3i User Manual page 81

RSTI-EP PROFINET I/O Controller User Manual
GFK-2571R
Figure 70: Selecting the Sub-Module Configuration with Jumper Settings Declared
Once the Content field has been populated, the Description field indicates how the physical
jumpers in the module should be configured. The +10 Vdc analog inputs selected in Figure
70 do not require the installation of jumpers on the module. If selected, the other choices
for this module would require jumpers. It is important to ensure that the jumper installation
matches the configuration for that module in PAC MACHINE EDITION. In the event the
jumper settings need to be altered due to changing channel requirements, the module
configuration in PAC MACHINE EDITION should be changed to match by retracing the steps
outlined in this section.
After choosing the submodule parameters of the module as described above, a subslot
appears in the Navigator, and the module's Configuration Mismatch is cleared:
Figure 71: Analog Modules Showing Configuration Mismatch Cleared
Configuring the Module Parameters
Double-click the subslot (not the module slot) in the Navigator to configure the module
parameters. The remaining configuration steps for these modules is the same as for other
VersaMax modules.
For a list of VersaMax Analog module subslot configuration choices and jumper settings,
refer to Configuring Analog Modules that Have Jumpers in the VersaMax PROFINET Scanner
Manual, GFK-2721.
Configuration
Section 3
May 2021
74