Installing Power Supplies Between Modules - Emerson PACSystems RX3i User Manual

RSTI-EP PROFINET I/O Controller User Manual
GFK-2571R
Figure 66: Select VersaMax Module from Available List
To delete a module from the left-side pane, select it and press the keyboard Delete key.
When the modules in the left side pane are correctly situated, click OK to add them to the
Configuration.
3.7.4

Installing Power Supplies Between Modules

Additional power supplies may be installed between modules, if necessary. Power Supply
modules added in this fashion will service the power requirements of modules located
further right in the same rack.
To add a power supply between modules, expand the Power Supply Module node in the
Change Module List. Select the desired power supply from the list. When you drag the power
supply to the left pane, additional rows labeled power appear between the previously listed
modules. Drop the power supply into its intended location.
Figure 67: Adding Power Supplies between Modules in PNS Rack
Click OK to add the module(s) to the Configuration.
Configuration
Section 3
May 2021
71