Emerson PACSystems RX3i User Manual page 19

RSTI-EP PROFINET I/O Controller User Manual
GFK-2571R
Figure 4: PNC001 Ethernet Ports Location and Type
For the Embedded PROFINET LAN (LAN2), CPL410, CPE400 and CPE330 both provide two
RJ45 ports identical to those shown as Port 1 and Port 2 in Figure 4. The operational
behavior, configuration parameters and diagnostics are also identical. Refer to the
corresponding product documentation for further details.
Small Form-factor Pluggable (SFP) cages (like Port 3 and Port 4 in Figure 4) are not offered
on CPL410, CPE400, CPE330 nor on CPE100/CPE115.
Figure 5: CPE100/CPE115 Ethernet Ports Location and Type
The CPE100/CPE115 Embedded PROFINET LAN (LAN2) supports three switched 8-
conductor RJ45 shielded twisted pair 10/100 Mbps copper interfaces ports as shown in
Figure 5. The operational behavior, configuration parameters and diagnostics are identical
to PROFINET port of CPE400. Refer to the corresponding product documentation for further
details.
CPE100/CPE115 LAN2 Port 2 and Port 3 can use redundant media for the PROFINET
network. Use of redundant media must first be set up in the module configuration. Section
6 provides additional information about Redundant Media.
Ethernet Port Status Indicators
Each external switched port has an associated link-up/link-down status bit that can be
monitored by the RX3i CPU to check the operating status of the port (see Status Reporting
in Section 5: Diagnostics
for information about the PROFINET Controller status bits). In addition, the Port Number
LEDs on the front of the module provide a visual indication of the port status.
Introduction
Section 1
May 2021
12