Ethernet Network Ports - Emerson PACSystems RX3i User Manual

RSTI-EP PROFINET I/O Controller User Manual
GFK-2571R
Topic
Appearance
Case
Attachment to Rack
Heatsink
Status LEDs
LED Behavior
Ethernet Port LEDs
µUSB Port
Command Line Interface
RJ45 Connector on
Faceplate
Power Requirements
Operating Temperature
Range (Surrounding Air)
Module Reset
With the Exception for the Command Line Interface, the -Bxxx version is functionally
compatible with the -Ax version.
1.5.2

Ethernet Network Ports

Figure 4 shows the underside of the PNC001 module.
• Ports 1 and 2 are standard RJ45 connections.
• Ports 3 and 4 offer Small Form-factor Pluggable (SFP) cages
The PROFINET Controller connects to a PROFINET network via one or more of its four
external switch ports. Two 8-conductor RJ45 shielded twisted pair 10/100/1000 Mbps
copper interfaces and two SFP cages provide flexibility in media selection and the ability to
use redundant media for the PROFINET network. Use of redundant media must first be set
up in the module configuration. Section 6: provides additional information about
Redundant Media.
The PROFINET protocol supported by the PACSystems RX3i PROFINET modules can be sent
and received over any of the four external ports on PNC001.
The PNC001 module is assigned five Ethernet MAC addresses: one for each of the four
external Ethernet ports and one for the internal switch.
Introduction
-Ax
Figure 2
Plastic
Via plastic case latch and
heatsink screw
Remove plastic knockout from
rack
6 LEDs
See Section 2.8
4 singleton LEDs (top of
faceplate)
Present
Uses Micro USB Port
Absent
Higher (see Section 1.3)
0 to 60°C
Pushbutton "Restart"
-Bxxx
Figure 3
Metal
Via two Phillip's head machine
screws
No knockout removal required
5 LEDs (no USB LED)
See Section 2.8
4 banks of LEDs (bottom of
faceplate)
The digits representing the port
numbers are backlit by LEDs.
Absent
Not available
Present (Disabled)
Lower (see Section 1.3)
-25 to 60°C
Membrane "Reset"
Section 1
May 2021
11