Configuring Versamax Module Parameters - Emerson PACSystems RX3i User Manual

RSTI-EP PROFINET I/O Controller User Manual
GFK-2571R
Figure 68: VersaMax PNS Rack showing Power Supply Located between I/O Modules
3.7.5

Configuring VersaMax Module Parameters

After adding VersaMax modules to the remote node, the parameters for each must be
configured. For all VersaMax modules, this includes configuring a set of basic parameters
(such as: Reference Address, Length, Scan Set, Carrier, Report Faults). Configuration details
for those basic parameters are provided in the Configuration Section of the VersaMax
PROFINET Scanner Manual, GFK 2721.
Configuring Analog Modules Requiring Jumper Settings
The following VersaMax analog modules use jumpers to select their voltage / current
operation or output defaults mode.
CAT Number
IC200ALG230
IC200ALG260
IC200ALG262
IC200ALG264
IC200ALG266
IC200ALG320
IC200ALG321
IC200ALG322
IC200ALG325
IC200ALG326
IC200ALG327
IC200ALG328
Configuration
Description
Analog Input Module, 12-bit Voltage/Current 4 Channels
Analog Input Module, 12-bit Voltage/Current 8 Channels
Analog Input Module, 15-bit Current Differential 8 Channels
Analog Input Module, 15-bit Current 15 Channels
Analog Input 15-bit Current 15Ch with enhanced over voltage
protection
Analog Output Module, 12-bit Current, 4 Channels
Analog Output Module, 12-bit Voltage 4 Channels. 0 to +10Vdc Range
Analog Output Module, 12-bit Voltage 4 Channels. -10 to +10Vdc Range
Analog Output Module, 13-bit Voltage 8 Channels
Analog Output Module, 13-bit Current 8 Channels
Analog Output Module, 13-bit Voltage 12 Channels
Analog Output Module, 13-bit Current 12 Channels
Section 3
May 2021
72