Emerson PACSystems RX3i User Manual page 156

RSTI-EP PROFINET I/O Controller User Manual
GFK-2571R
PROFINET MRP Port Status TLV
The PROFINET MRP Port Status indicates the current MRP status of the network port over
which this LLDP message is sent.
This TLV is required when the LLDP sender is an MRP port. It is not present in the LLDP packet
issued from a non-MRP port.
The PROFINET Controller supports the following values:
Subfield
MRP Domain ID
MRRT Port Status
PROFINET Chassis MAC TLV
The PROFINET Chassis MAC indicates the internal MAC address used by the PROFINET stack.
This is not the MAC address of any individual network port.
MAC/PHY Config/Status TLV
The MAC/PHY Configuration/Status indicates the supported auto-negotiation capability,
the current negotiated capability, and the Medium Attachment Unit (MAU) type of the
network port over which this LLDP message is sent.
Field
Auto-negotiation
Support/Status
Auto-negotiation
Advertised
Capability
Network Management
Value
Contains the MRP domain UUID. Assigned internally by the network node.
Set to 0xFFFFFFFF-FFFF-FFFF-FFFF- FFFFFFFFFFFF.
0x00 = Off / Not Used
Values
Bit 0: Auto-negotiation supported (1=
Yes, 0 = No)
Bit 1: Auto-negotiation status
(1 = Enabled, 0 = Disabled)
Bits 2-7: Reserved
Note: There are no AutoNegCapability
definitions for 100Base FX or LX (HD or
FD). A device that supports these must
advertise "Other".
RX3i PROFINET Controller
0x03 (Auto-negotiation supported
and enabled)
Copper Ports:
0x6C03 = 10/100/1000T HD+FD
SFP Ports:
(Depends on SFP type)
0x000C = 1000 LX/SX HD+FD
0x6C03 = 10/100/1000T HD+FD
0x8000 = Other (100 FX, LX)
SC Fiber Ports:
0x8000 = Other (100 FX)
Section 7
May 2021
149