PACSystems VersaMax Genius Network Interface User Manual
GFK-1535D
Section 2:
This section gives instructions for installing the Network Interface Unit
and the Genius® bus.
Module clearance
•
Thermal considerations
•
Mounting instructions
•
Panel-mounting
•
Installing an Expansion Transmitter Module
•
Installing an Expansion Receiver Module
•
Installing Power Supply Modules
•
Installing Additional Modules
•
Setting the SBA and baud rate
•
Special switch settings on the NIU
•
Selecting a cable type
•
Making bus connections
•
Observing the LEDs
•
CE Mark installation requirements
•
Additional installation instructions are located in the VersaMax Modules,
Power Supplies, and Carriers Manual, GFK-1504.
WARNING
•
•
•
Installation
Installation
Explosion hazard - substitution of components may impair suitability for Class I,
Division 2;
Explosion hazard - when in hazardous locations, turn off the power before replacing
or wiring modules; and
Explosion hazard - do not connect or disconnect equipment unless power has been
switched off or the area is known to be non-hazardous.
Section 2
Jan 2023
17