Using The Folder - GIRBAU PB32 Series Installation, Operation And Maintenance Instructions Manual

7.5.4. Using the folder

The folder allows the linen items ironed by the machine to be folded lengthwise.
Three folding modes
Manual mode
The user must enter the length of the part to be folded using the control panel keyboard.
Alternatively, the ironer control can measure and memorise the length of the part to be folded.
The ironer control automatically determines the number and length of the folds.
This is recommended where the articles to be folded are of equal length, and the width of the fold is not a
critical measurement.
Advanced manual mode
The user must enter the length of the part to be folded using the control panel keyboard.
Alternatively, the ironer control can measure and memorise the length of the part to be folded.
The ironer control offers the possibility of defining the number of folds.
Recommended where the items to be folded are of the same length and the user wishes to define the type of
fold.
Automatic mode
The ironer control automatically determines the number and length of the folds.
Recommended when the folded items are of different lengths and do not require very accurate folding.
Measuring and memorising the dimensions of an item of linen
Once an ironing program is running, wait until there are no articles of linen inside the ironer.
Access the position Changing the folding mode (section 7.5.7.). The display shows the programmed length
of the items to be folded.
Insert an item of linen. The ironer measures the inserted item. The item's measurements appear on the
display.
Press the MOD key once the measuring has finished. The measured value will become the new
programmed length value.
During the ironing process, the length of each item entered will be displayed on the ironer display (position F
in the above image). If the measurement for the items to be ironed differs constantly from the programmed
length, modify the value.
CAUTION!
Cleaning the linen feed detectors
To ensure the ironer operates properly, it is very important to clean the feed detection photocells located on
the ironer's linen feeding tray.
Clean off lint and dust residues with a dry cloth. If necessary, use a slightly damp cloth.
Never use any abrasive element or anything that might damage the surface of the photocells.
Expelling an item of linen from the input tray
Pressing the EXPULS key on the multifunction keyboard activates the linen expulsion straps.
DANGER!
NEVER ATTEMPT TO REMOVE A PIECE OF LINEN STUCK IN THE FOLDER WITHOUT FIRST
TURNING OFF THE POWER TO THE IRONER COMPLETELY.
ALWAYS PROTECT YOUR HANDS WITH HEAT-INSULATED GLOVES.
Operating and use. Inteli Control
87
Code no. 550038
Rev. no. 16/1018